iLive ITP180B - Manual (Page 15)

CUSTOMER HELPLINE | 1-314-621-2881 iLive | ITP180B 15
Getting Started
1 Use the Tape Measure to decide
how high you’d like to hang the bar
speaker on the wall.
The bar speaker must be hung within
6 feet of an AC power outlet for the
attached AC power cable to reach.
2 Use the Stud Finder to locate 2
parallel wooden studs to screw the
mounting brackets into.
3 Mark the wall at the center of the
studs using the pencil.
4 Line the level up on both of your
marks to make sure they are level.
If they’re not, adjust the marks as
needed to make them level.
5 After you’ve double checked your
markings, drill through the top hole
on both mounting brackets directly
into the marks you’ve made on the
wall.
6 If you are using the brackets only
and no spacers, use the included
short screws. If you are using any of
the spacers or combination of the
spacers, use the long screws.
7 Use the Level to level each of the
hanging brackets, then drill the
second screw into the bottom hole
on both mounting brackets.
8 Slide the bar speaker onto the
mounting brackets, and make sure
there is a firm and stable connection
before letting go of the bar speaker.
9 Finally, use the Level to confirm that
the bar speaker is level.
16”
ITP180B
ITP180B
screws
studs
mounting
bracket
spacer