Interphase Tech RAS Communications Controller 5536 - Manual (Page 67)

Chapter 4: Installing the Software
5536 PRI RAS Communications Controller Users Guide 47
Figure 4-8. ISDN PRI Port Properties
2. Depending on your geographic location and other
considerations, change the default switch type and/or
other parameters, as needed.
If you selected a North American switch type, use the
DS1 properties button to activate the board’s internal
CSU for port connections.
For detailed information about ISDN PRI port
properties, see
Setting Up ISDN Port Properties on
page 80 .
C
AUTION
You must select the same switch type for all ports on a
single board. Otherwise, the ports might not function
properly.
3. When you finish the port setup, click OK.
The WAN Adapters Setup dialog box reappears.