Integra DTR-7.8 - Manual (Page 55)

55
First Time Setup —Continued
Notes:
• When the automatic speaker setup is complete, the
Equalizer Settings (page 101) will be set to Audyssey.
• You can cancel the automatic speaker setup at any
point in the procedure simply by disconnecting the
setup microphone.
Error Messages
During the automatic speaker setup, one of the following
error messages may appear:
Ambient noise is too high
This message appears if there’s too much background
noise and the measurements cannot be performed prop-
erly. Remove the source of the noise and try again, or
cancel the automatic speaker setup.
7 After the 3rd or 7th measurement, the
following screen appears.
Use the Up and Down [ ]/[ ]
buttons to select an option, and
then press [Enter].
Next: Select this if you want to mea-
sure another listening posi-
tion. After the 8th
measurement has been taken,
the procedure automatically
proceeds to step 8.
Finish (Calculate): Select this if you
don’t want to measure any
more listening positions and
are ready to calculate the
results, then go to step 8.
8 When the measurements are
complete, the following screen
appears.
9 When the calculations are com-
plete, the following screen
appears.
Use the Up and Down [ ]/[ ]
buttons to select an option, and
then press [Enter].
Save: Save the calculated settings
and exit the automatic
speaker setup.
Review SP Config: Review the
speaker configuration settings
(see “Reviewing the Results”
on page 57).
Enter
Enter
Auto Speaker Setup
Please select “Next”, when measuring
next position, and select “finish”,
when ending.
Next
finish(Calculate)
AUDYSSEY
Auto Speaker Setup
Calculating...
AUDYSSEY
Enter
Enter
Auto Speaker Setup
Save
Review SP Config
Review SP Distance
Review SP Level
Cancel
AUDYSSEY
Review SP Distance: Review the
speaker distance settings (see
“Reviewing the Results” on
page 57).
Review SP Level: Review the speaker
level settings (see “Reviewing
the Results” on page 57).
Cancel: Cancel the automatic speaker
setup.
10 If you selected “Save,” the results are
saved, and the following screen
appears.
11 Disconnect the setup micro-
phone.
Auto Speaker Setup
Saving...
AUDYSSEY
Auto Speaker Setup
Please unplug microphone.
AUDYSSEY
Auto Speaker Setup
Ambient noise is too high.
Retry
Cancel
AUDYSSEY