Impex MWM7150 - Manual (Page 8)

ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and
Allen Wrenches. NOTE: It is strongly recommended that two or more people
assemble this machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten the nuts and bolts until instructed to do so.
B.) Slide two Ø 2 ½” x 1” Rubber Bumpers (#33) onto the Guide Rods (#10). Insert
the two Guide Rods into the holes on the Rear Base Frame (#5). Secure each
Guide Rod with one M10 x 1” Allen Bolt (#47) and
∅
¾” Washer (#59) from the
bottom.
C.) Attach the rear of Main Frame (#1) to the Rear Base Frame. Secure them with two
M10 x 2 ¾” Carriage Bolts (#46), one U-shaped Bracket (#16), two Ø ¾” Washers
(#59), and two M10 Aircraft Nuts (#56).
D.) Attach the Front Post (#6) to the Main Frame. Secure them with two M10 x 2 ¾”
Carriage Bolts (#46), one 4 ¾” x 2” Bracket (#18), two Ø ¾” Washers (#59), and
two M10 Aircraft Nuts (#56).
E.) Attach the Seat Support (#17) onto the Main Frame. Secure them with two M10 x
2 ¾” Carriage Bolts (#46), one 4 ¾” x 2” Bracket (#18), two Ø ¾” Washers (#59),
and two M10 Aircraft Nuts (#56).
F.) Attach the Foot Plate (#14) onto the Front Post. Secure it with two M10 x 5/8”
Allen Bolts (#48) and two Ø ¾” Washers (#59).
7