Declaration of conformity (doc), Product specifications – i. Tech Dynamic i.Tech i. Car Kit User Manual

Page 3

Advertising
background image

9

Declaration of Conformity (DOC)

Please note the i.Tech i.Carkit does not currently work with SonyEricsson P800, T68i
(Handsfree only) and Siemens SK65.
If the above steps do not resolve your problem, please reset your headset, remove both
the batteries a while.
The i.Tech i.Carkit is compliant with and adopts the Bluetooth Specification 1.2. However,
interoperability between the device and other Bluetooth-enabled products is not
guaranteed because it depends on compatibility. For more information on the
compatibility between the device with other Bluetooth-enabled products, please check
with manufacturer or browse: http://www.itechdynamic.com.

We, i.Tech Dynamic Ltd., declare that the following product:

Product Name: i.Tech i.Carkit
Model No.: C51-A06115-XX

Is in conformity with the following essential requirements of Council Directive
1999/5/EC(referred to as R&TTE Directive): Article 3.1a, 3.1.b and 3.2. and the product is
manufactured in accordance with Annex II of above directive.

A copy of the Declaration of Conformity can be found at:

http://www.itechdynamic.com

10

Product Specifications

Bluetooth Specification:

v1.2 Class 2

Bluetooth Profiles Supported:

Headset and Handsfree

Range of Frequency:

2.4GHz Specturm

Transmitting Range:

Up to 10 meters

Input Voltage:

DC 12V – 24V

Dimensions:

115 (L) x 63 (W) x 30 (H) mm

Weight :

81 grams

* May vary with difference type of batteries and user mode of operation.

2007 Hutchison Harbour Ring Enterprises Limited
All rights in this publication are reserved and no part may be reproduced without the prior written
permission of the publisher. The contents of this publication are believed to be correct at the time of
going to press, but any information, specifications, products or services mentioned may be modified,
supplemented or withdrawn without further notice.
The Stylized i.Tech logos are trademarks owned by Hutchison Harbour Ring Enterprises Limited or its
affiliates.
Bluetooth and the Bluetooth logos are trademarks owned by Bluetooth SIG, Inc, USA and licensed to
i.Tech Dynamic Limited.
i.Tech declares under our sole responsibility that the product is in conformity with the provisions of the
following Council Directives: 1999/5/EC

11

Federal Communications Commission (FCC) Statement

15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

Operation is subject to the following two conditions:

1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation
of the device.

FCC RF Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Dispose of the packaging and this product in accordance with the latest provisions.

www. itechdynamic.com 12/07 Printed in China

Advertising