Icom IC-M422 - Manual (Page 55)

49
12
COMMANDMIC II™ HM-157
New2001
12
■ Set mode programming
Set mode is used to change the condition of the transceiver’s
functions and the microphone’s own functions:
Transceiver’s functions—
Scan type, Scan resume timer, Weather alert, Dual/Tri-watch,
Beep tone*
1 , LCD backlight* 1 , LCD contrast* 1 and Radio
PWR.
Microphone’s own functions—
Beep tone*
2 , LCD backlight* 2 and LCD contrast* 2
* 1 For transceiver setting
* 2 For microphone setting
In this section, instructions are for the microphone’s own func-
tions only. Refer to pgs. 32 to 34 for the setting of the other
functions. (Some functions cannot be selected from the
HM-157.)
D D Entering Set mode
q Turn power OFF.
w While pushing [16•
9 ], turn power ON.
• After a beep emission, a Set mode item appears at the channel
comment indicator.
e After the display appears, release [16• 9 ].
r Push [16• 9 ] to select the desired item, if necessary.
t Push [Y Y] or [Z Z] to select the desired condition of the item.
y Turn power OFF, then ON again to exit Set mode.
• Beep tone
You can select the silent operation
by turning beep tones OFF or you
can have confirmation beeps
sound at the push of a key by turn-
ing beep tones ON.
• LCD backlight
The LCD backlight brightness can
be adjusted from OFF, 1 (dark) to
7 (bright.)
•
“ ” scrolls at the channel
comment indicator.
• LCD contrast
The LCD contrast can be ad-
justable in 4 levels. 1 is the lowest
contrast, and 4 is the highest con-
trast.
•
“ ” scrolls at the channel
comment indicator.
Scrolls
Scrolls
!IC-M422.qxd 05.2.23 2:21 PM Page 49 (1,1)