iHome iH16 - Manual (Page 8)

5
Listening to non-docking iPod or other audio devices
Setting the Clock Time
1. Press and hold the Clock Adj. Button for 2 seconds until the hour display flashes. Press the or Button until the
current hour is displayed. Remember to set the correct AM or PM time (a PM icon to the left of the time display is the PM
indicator; there is no AM indicator). Note that the PM indicator will not appear when using 24 hour display mode.
2. Press the Clock Adj. Button again. The minute display will flash. Press the or Button until the current minute is
displayed.
3. Press the Alarm Set Button during time setting to set 12-hour or 24-hour display format.
4. Press the Clock Adj. Button again to confirm the clock setting. You should hear 2 beeps indicating the clock time is set.
5. Press the DST on/off Button located on the back of the unit to add one hour for daylight saving time (on) or to subtract
one hour for standard time (off). The icon will appear on the display to indicate DST is on.
Setting Up the iH16
1. Plug one end of an audio cable ( available at www.ihomeaudio.com) into the headphone or line-out jack on your device
and the other end of the patch cord into the iH16 Aux-in Jack.
2. Press the button to turn the iH16 on.
3. Press the or Buttons on the iH16 to adjust the system volume. You may need to adjust your device volume, too.
4. To turn off the iH16, press the button. Please remember to turn off your device, too.
NOTE: Do not connect and try to play an aux audio device while a docked iPod is playing or you will hear both.