Insignia NS-A2110 - Manual (Page 12)

12
Insignia NS-A2110 Executive Shelf System
www.insignia-products.com
To repeat an entire program:
1 Press REPEAT twice while the program is playing.
2 To cancel repeat, press REPEAT again.
Troubleshooting
Caution
Do not try to repair the shelf system yourself. Doing so will
invalidate your warranty.
Problem Possible cause Solution
No sound or
power Volume too low. Turn up the volume.
AC power cord not securely
connected. Connect the AC power cord.
The CD does
not play The CD was incorrectly
inserted. Reinsert the CD, label side up.
The CD is defective. Try another CD.
The CD compartment is not
closed. Close the CD door.
There is condensation in the
CD compartment. Remove the CD and leave the
cover open for about an hour in a
dry environment.
No disc
indicated on the
display No CD inserted. Insert a CD, CD-R, or CD-RW disc.
The CD is badly scratched or
dirty. Clean the CD if it’s dirty. Replace
the CD if it’s defective.
There is condensation in the
CD compartment. Remove the CD and leave the
cover open for about an hour in a
dry environment.
You are using a CD-R or
CD-RW that is blank or the
disc has not been finalized. Use a finalized CD-R or CD-RW.
No sound in the
headphones. The headphone jack is not
correctly inserted. Reinsert the headphone plug into
the jack.
The volume control is turned
down. Increase the volume.
The CD is defective. Try another CD.
The CD skips
during play. The CD or lens is dirty. Clean or replace the CD, or clean
the lens.
Strong shaking or vibrations Place the shelf system on a flat and
stable surface without vibration.
The CD player is programmed
to skip a track. Quit the Program mode.