IBM Partner Pavilion iLC300 - Manual (Page 25)

Left and right remote mouse buttons are used to mimic the actions of the left/right
mouse buttons on your computer. Mouse cursor movement is managed via the
remote’s Cursor control. Connect the USB connector on the computer cable to your
computer to use these buttons and control your computer’s mouse. When you do
this for the first time, the Add New Hardware wizard may appear.
Press the remote’s Menu button to open the projector’s menu system. Use the
arrow buttons to navigate, and the Select button to select features and adjust
values in the menus. See Chapter 5, “Using the menus”, on page 19.
The remote also has a power button to turn the projector on and off (see “Shutting
down the projector” on page 18 for shutdown info), volume and mute buttons to
control the sound, a backlight button to light the remote’s buttons in the dark, and
video and computer buttons to switch between sources.
Two presentation-specific features are also provided. Use the blank button to
display a blank screen instead of the current slide; use the effect button to invoke a
user-definable action, such as freeze or zoom.
If you are displaying presentations in Microsoft ® PowerPoint ® , you can use the
remote’s mouse buttons to navigate through your presentation while in Slide Show
mode. To configure PowerPoint for this, choose Options from the PowerPoint
Tools
menu, click the View tab, de-select the “Popup Menu on Right Mouse Click”
option in the Slide Show section, then click OK. Then, when you’re in
PowerPoint’s Slide Show mode, a left click advances to the next slide and a right
click returns to the previous slide (other PowerPoint modes are not affected).
Troubleshooting the remote
v Make sure the batteries are installed in the proper orientation and are not dead.
v Make sure you’re pointing the remote at the projector, not the computer, and are
within the remote range of 30 feet (9.14m).
v If you are trying to control your computer’s mouse, make sure the USB cable is
connected. If using a USB cable, make sure the correct drivers are installed.
Using the audio
To play sound from the projector, connect your source to the Audio In connector
on the projector.
computer 1 computer 1 computer 2 computer 2
video
monitor network network
serial control serial control
audio in audio in
audio in audio in audio in audio in
audio out audio out
R
R
L
L
Y
Pr
Pb
s-video
computer in computer in
To adjust the volume, use the buttons on the keypad or remote.
To mute the sound, press the Mute button.
Chapter 4. Using the projector features 15