I-Data POLARIS Panel PC 19.1" - Manual (Page 22)

User manual
POLARIS Panel PC 19.1'' and Panel PC 15''
Version 2.00
Page 22 of 46
E_BMS790_POLARIS_PanelPC_19+15_Rev1.doc • User manual for POLARIS Panel PC 19.1" and 15" • Revision 1 / Status: January, 3 rd , 2006 • Technical data subject to change
5. Notes on the installation of POLARIS Panel PC
5.1 Safety instructions
For electrical appliances, the appropriate regulations for setting-up and operation have to be observed
(e.g. directive 1999/92/EC, directive 94/9EC, BetrSichV and national regulations/acts, IEC/EN 60 079-14 and VDE 0100).
The operator of an electrical appliance in an area where there is an explosion hazard has to maintain the resources in a
proper condition, operate them correctly, monitor them and carry out maintenance and repair work (BetrSichV and national
regulations/acts and EN 60 079-14).
Where the IP rating is concerned, only original replacement parts may be used (e.g. lid seal).
The unit may be opened only in the manufacturer's works!
The unit is factory sealed! Do not open!
5.1.1 Safety-relevant notice
Inside areas of explosive atmospheres any electrostatic charging mechanism on the surface of the indicating terminals have
to be excluded if they are stronger than manual rubbing (e.g. cleaning by hand).
5.2 Maintenance
For the maintenance, servicing and checking of associated resources, adhere to the valid regulations in accordance with
directive 1999/92/EC, IEC 60079-19 and EN60079-17 !
Installation / dismantling, servicing and maintenance work may only be carried out by trained specialists. The general
statutory regulations and other binding directives on workplace safety, accident prevention and environmental protection
must be adhered to.
Observe the national disposal of waste regulations when disposing of this equipment at the end of its useful life.
5.2.1 Servicing
If operated correctly, in accordance with the installation instructions and environmental conditions, no regular servicing is
necessary.
5.2.2 Inspection
In accordance with IEC 60079-19 and EN 60079-17, the site operator has an obligation to ensure that any electrical
appliance installed within, an area containing gases and dust, which could be potentially explosive, is correctly installed by
trained personnel and that the installation is regularly inspected and correctly maintained to ensure the safety of the
operatives in the area.