Appendix e: updating firmware – Intellinet Network Solutions PRO SERIES INT-PSNC-UM-1106-06 User Manual
Page 98
- 98 -
Appendix E: Updating Firmware
CAUTION: The process for updating current firmware is already installed in your camera. If you
begin the process, follow the manual instructions. During the process, do not disconnect the
network or power source, and avoid any physical shock to the camera. Otherwise, the camera
can be seriously damaged and fail to function properly. If firmware fails to update, or if the
camera does not operate properly after a firmware update, contact your local dealer.
Identify the Version of Firmware
You can identify the version of the camera’s firmware on the System Configuration page.
(You can check the version of your camera firmware first and then try to update.) To check the
present version of firmware, go to the camera’s homepage and click "Administrator Tools"; then
go to the System Configuration page and check the version of the firmware.
Download New Firmware
You can download the latest firmware software through the Internet at the INTELLINET
NETWORK SOLUTIONS support Web site: www.networkipcamera.com.
Install New Firmware
Camera firmware can be upgraded via the LAN or
remotely over the Internet.
1. Confirm that the camera is connected to your PC.
(As long as you can access your camera homepage,
you can process an upgrade.)
2. Execute the newly updated firmware and select the
firmware file via the "Firmware Open" button.
3. Enter the camera’s IP address, upgrade port
number, admin ID and password configured on the
Network Configuration page. Then click on "Start
upgrade." You may see the upgrading status.
Upgrading levels are divided into four steps, from
"Transferring Firmware" to "Verifying flash memory."
(Each step is indicated on a progress bar.)
4. When completed upgrading, a message appears
that indicates the upgrade has been completed.
Click the "OK" button.
NOTE: If you receive the warning "INVALID HEADER
MARKER" during the firmware upgrade, restart your computer
in safe mode with networking support and repeat the procedure.