IBM L170 - Manual (Page 23)

20
Further Information
Display Modes
Your computer controls the monitor’s display mode. Refer to your computer
documentation for details on how to change display modes.
The image size, position and shape might change when the display mode
changes. This is normal and the image can be readjusted using
I MAGE S ETUP
( ) and the monitor controls.
Unlike CRT monitors, which require a high refresh rate to minimize flicker,
TFT technology is inherently flicker-free. If possible, configure your computer
for 1024 × 768 addressability at 60Hz vertical refresh rate.
For the display modes listed on the next page, the screen image has been
optimized during manufacture.
For image problems, you
may want to run AUTO
Setup again before consulting this
section. In most cases, AUTO
SETUP can fix the problems. See
Image Setup (
)
for DOS on
Page 12 for details.
Factory Set Display Modes
† Recommended
Note: VESA timings are as detailed in the VESA “Display Monitor Timing Specification”.
Version 1.0, Revision 0.8, dated 09/17/98.
Addressability Refresh Rate Horizontal Frequency
640 × 350 70 Hz 31.5 kHz
640 × 480 75 Hz 37.5 kHz
640 × 480 72 Hz 37.8 kHz
640 × 480 66 Hz 35.0 kHz
640 × 480 60 Hz 31.5 kHz
720 × 400 70 Hz 31.4 kHz
800 × 600 56 Hz 35.1 kHz
800 × 600 60 Hz 37.8 kHz
800 × 600 72 Hz 48.0 kHz
800 × 600 75 Hz 46.8 kHz
832 × 624 75 Hz 49.7 kHz
1024 × 768 60 Hz 48.4 kHz
1024 × 768 70 Hz 56.5 kHz
1024 x 768 75 Hz 60.0 kHz
†