Indesit Dishwasher ICD - Manual (Page 6)

4
4. Prior using for the first time
NOTE: If your model have no water softener, you may skip this section.
A. Loading the Salt Into the Softener
Always use salt intended for use with dishwasher.
The salt container is located beneath the basket and should be filled as follows:
Attention
„
Only use salt specifically designed for use in dishwashers! All other types of salt not
specifically designed for use in a dishwasher, especially table salt, will damage the water
softener. In case of damages caused by the use of unsuitable salt the manufacturer does not
give any warranty nor is liable for any caused damages.
„
Only fill with salt just before starting one of the complete washing programmes. This will
prevent any grains of salt or salty water, which may have been split, remaining of the bottom of
the machine for any period of time, which may cause corrosion.
Remove the basket and then unscrew and remove the cap from the salt container.
Before first wash, add 1lt. of water in the salt container of your machine.
Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
It is normal for a small amount of water to come out of the salt container.
After filling the container, screw the cap tightly back clockwise.
Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has been filled with salt.
Immediately after filling the salt in to the salt container, a washing programme should be started (Suggest choose
program). Otherwise filter system, pump or other important parts of the machine may be damaged by salty water. It is out
of warranty.
NOTE:
1. The salt container must only be refilled when the salt warning light in the control panel comes on.
Depending on how fully the salt dissolves, the salt warning light may still be on even though the salt
container is filled.
If there is no salt warning light in the control panel (For some Models), you can judge when to load the
salt into the softener by the cycles that the dishwasher had run.
2. If there a re spills of the salt, a soak or a rapid program should be run to remove the excess salt.
B. Fill the Rinse Aid Dispenser
Rinse Aid Dispenser
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes. That can leave spots and
streaks. It also improves drying by allowing water to sheet off the dishes. Your dishwasher is designed to use liquid rinse aids.
The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the dispenser, open the cap and pour
the rinse aid into the dispenser until the level indicator turns completely black. The volume of the rinse aid container is about
110ml.
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.
F
E
D
C
B
A
2
1
Open