Invacare PRONTO R2-250 - Manual (Page 17)

17
F
R
O
N
T
R
I
G
G
I
N
G
S
PROCEDURE 3 FRONT RIGGINGS
RAISING/LOWERING ELEVATING
LEGRESTS AND/OR ADJUSTING
CALFPADS (FIGURE 6)
Raising/Lowering Elevating Legrests
1. Perform one (1) of the following:
RAISING - Pull back on the release lever
until the leg is at the desired
height.
LOWERING - Support leg with one (1) hand
and push release lever down-
ward with other hand.
Adjusting Calfpads
1. Turn calfpad towards the outside of the wheelchair.
2. Slide the calfpad up or down until the desired posi-
tion is obtained.
NOTE: If one (1) of the top two (2) calfpad adjustment
positions is being used, the legrest will need to be raised
to avoid interference with the front stabilizers while going
over obstacles or going up and down ramps. Refer to
RAISING/LOWERING ELEVATING LEGRESTS in this
procedure of the manual.
3. Turn the calfpad towards the inside of the wheel-
chair.
Release Lever
Calfpad
Calfpad
Rotated for
Height
Adjustment
FIGURE 6- RAISING/LOWERING ELEVATING
LEGRESTS AND/OR ADJUSTING CALFPADS
Top Two (2) Calfpad
Adjustment Positions
ADJUSTING/REPLACING
TELESCOPING FRONT RIGGING
SUPPORT (FIGURE 7)
Adjusting
1. Remove the two (2) mounting screws, spacers and
locknuts that secure the telescoping front rigging sup-
port to the seat frame.
2. Perform one (1) of the following:
A. Slide existing telescoping front rigging support to
one (1) of three (3) depth positions.
B. Remove existing telescoping front rigging support
and install NEW telescoping front rigging support.
3. Secure telescoping front rigging at desired depth with
existing two (2) mounting screws, spacers, and lock-
nuts. Securely tighten.
NOTE: The two (2) telescoping front rigging supports
can be positioned at different depths depending on the
need of the user.
Replacing
NOTE: Observe the position of the current telescoping
front rigging support before removal to ensure correct
position of new support assembly.
1. Remove the existing telescoping front rigging sup-
port from the wheelchair.
2. Install the new telescoping front rigging support into
the wheelchair.
3. Adjust the telescoping front rigging support. Refer to
ADJUSTING TELESCOPING FRONT RIGGING
SUPPORT in this procedure of the manual.
FIGURE 7 - ADJUSTING/REPLACING TELESCOPING
FRONT RIGGING SUPPORT
Mounting Screws
Seat Frame
Spacers
Locknut Telescoping
Front Tube