IBM 12.1(22)EA6 - Manual (Page 279)

C H A P T E R
14-1
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
14
Configuring IGMP Snooping and MVR
This chapter describes how to configure Internet Group Management Protocol (IGMP) snooping on your
Cisco Systems Intelligent Gigabit Ethernet Switch Module, including an application of local IGMP
snooping, Multicast VLAN Registration (MVR). It also includes procedures for controlling multicast
group membership by using IGMP filtering and procedures for configuring the IGMP throttling action.
Note For complete syntax and usage information for the commands used in this chapter, see the switch
command reference for this release and the Cisco IOS Release Network Protocols Command Reference,
Part 1, for Cisco IOS Release 12.1
This chapter consists of these sections:
• Understanding IGMP Snooping, page 14-2
• Configuring IGMP Snooping, page 14-7
• Displaying IGMP Snooping Information, page 14-14
• Understanding Multicast VLAN Registration, page 14-15
• Configuring MVR, page 14-17
• Displaying MVR Information, page 14-21
• Configuring IGMP Filtering and Throttling, page 14-21
• Displaying IGMP Filtering and Throttling Configuration, page 14-27
Note For MAC addresses that map to IP multicast groups, you can either manage them through features such
as IGMP snooping and MVR, or you can use static MAC addresses. However, you cannot use both
methods simultaneously. Therefore, before using IGMP snooping or MVR, you should remove all
statically configured MAC addresses that map to IP multicast groups.