IBM RS/6000 44P - Manual (Page 171)

System Response Action
The Missing Resource menu is displayed. Follow the displayed instructions until either the
Diagnostic Mode Selection menu or an SRN is
displayed.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to “Step 12”.
If you get an SRN, record it, and go to “Step
14” on page 154.
The New Resource menu is displayed. Follow the displayed instructions.
Note: Devices attached to serial ports S1 or
S2 do not appear on the New Resource menu.
Also, ISA adapters do not appear unless they
have been identified and configured.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to “Step 12”.
If you get an SRN, record it, and go to “Step
14” on page 154.
If you do not get an SRN, go to “Step 17” on
page 155.
The system does not respond to selecting
diagnostics. Go to “Step 10” on page 152.
Step 12
Did the Diagnostic Selection Menu display?
NO If Problem Determination was selected from the Diagnostic Mode
Selection menu, and if a recent error has been logged in the error log,
the diagnostics automatically begin testing the resource.
Follow the displayed instructions.
v If the No Trouble Found screen is displayed, press Enter.
v If another resource is tested, repeat this step.
v If the Diagnostic Selection menu is displayed, go to “Step 13”.
v If an SRN is displayed, record it, and go to “Step 14” on page 154.
YES Go to “Step 13”.
Step 13
The All Resources option checks most of the configured adapters and devices.
Chapter 8. Hardware Problem Determination 153