Invacare ITFM - Manual (Page 4)

InTouch™ Flovair Seat 4 Part No 1141447
Removing/Installing Seat Covers
Removing the Outer Cover
ƽ WARNING
The covers are designed to protect the foam from moisture and to provide
fire retardency. DO NOT use the seat without either the inner or outer
cover. If the covers are torn, they must be replaced IMMEDIATELY.
1. Remove the seat from the seating surface. Refer to Attaching/Removing Seat
To/From Seating Surface on page 2.
2. Unzip the outer cover.
3. Remove seat, still inside the inner cover, from the outer cover.
CAUTION
DO NOT remove both the outer cover and inner cover at the same time,
otherwise damage to the inner cover material may occur.
Installing Outer Cover
NOTE: For this procedure, refer to FIGURE 2.
1. Position the seat with inner cover and the fluid/air insert in place toward the
rear of the outer cover.
NOTE: The fluid/air insert is at the top of the inner cover.
NOTE: The zipper is at the rear and the stretch fabric is at the top of the outer cover.
2. Slide the seat into the outer cover.
3. Zip the outer cover closed.
4. Reattach seat onto seating surface. Refer to Attaching/Removing Seat To/From
Seating Surface on page 2.
CAUTION
Use care not to snag the innercover in the outer cover zipper, or damage to
the inner cover will occur.
FIGURE 2 Removing/Installing Seat Covers - Installing Outer Cover
Outer
Cover
Inner Cover
Zipper
Seat