Invacare CTMT-F - Manual (Page 3)

Part No 1145733 3 Formula™ CG Tilt Manual Center Mount Front Rigging
FIGURE 1 Description of Kit
Removing the Existing Front Rigging Support
NOTE: For this procedure, refer to FIGURE 2.
1. Remove the two cap screws, two spacers and threaded block securing the front rigging
support to the side rail.
2. Remove the existing front rigging support.
3. Repeat STEP 1 and STEP 2 on the opposite side.
4. On the side of the wheelchair where the release handle will be mounted, remove the
side rail end cap.
NOTE: T‐nut will be installed on the same seat rail that the release lever will be mounted to.
5. Install the T‐nut (not shown) into the slot in the side rail.
6. Slide the T‐nut rearward.
7. Reinstall the side rail end caps.
FIGURE 2 Removing the Existing Front Rigging Support
2
3
4 7
1
5
24
6
2
4
8
9
12
15
10
14
11
20
20
23 22
21
25
19
18
17
16
13
Front Rigging
Supports
Cap Screws
Spacers
Threaded Blocks
Cap Screws
Spacers
NOTE: Side Rail End
Cap Not Shown
Slot in Side Rail