Invacare CTMT-F User Manual
Page 8
Formula™ CG Tilt Manual Center Mount Front Rigging
8
Part No 1145733
Adjusting the Height of the Manual Center Mount
Footrest
ƽ WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 6.
1. Loosen the two mounting screws that
secure the button head cleat to the
extension housing.
2. Adjust the footrest extension tube to
the desired height.
3. Secure the extension tube to the desired
height with the button head cleat and
mounting screws. Securely tighten.
4. Repeat STEPS 1‐3 for the other
extension tube.
FIGURE 6 Adjusting the Height of the
Adjusting the Angle of the Manual Center Mount
Footrest
ƽ WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 5 on page 7 and FIGURE 7.
1. Engage the release lever with one hand
(not shown) and move the center
mount footrest to the desired angle
with the other hand.
NOTE: Refer to FIGURE 5 for the location of
the release lever.
2. Disengage the release lever (not shown)
to lock the center mount footrest in the
new position.
FIGURE 7 Adjusting the Angle of the
Extension Housing
Extension
Tube
Mounting
Screws
Extension Tube
Mounting Holes
Button
Head Cleat
Footplate
Center Mount
Footrest