IBM ILM300 User Manual
Page 4
How to view the online User Guide
To view the online multi-language iLM300 MicroPortable Projector User
Guide on the CD, do the following:
1.
Insert the User Guide CD into the CD-ROM drive.
2.
The CD will start. Go to step 5. If the CD does not start, click
Start, and then click Run.
3.
Type
e:\
launch.bat, where e: is the CD-ROM drive.
4.
Click OK. The CD browser page is displayed.
5.
Follow the on-screen instructions.
Additional Help
The iLM300 User Guide includes comprehensive instructions on setting
up and operating your projector. Here are some common setup issues and
how to solve them.
1.
Nothing appears on the screen.
Make sure you have attached the power cable, removed the lens cap, and
pressed the power button on the top of the projector.
2.
All I see is the start up screen.
Make sure the computer cable is connected between the computer and the
projector. Try pressing the mobile computer activation keys more than
once. Some machines require pressing the keys twice to activate the
image.
Be certain you are using the right combination of activation keys for your
computer. Appendix C in the online User Guide contains a list of key
combinations for many mobile computers.
3.
There is no computer image on the screen.
The projector might not synchronize with the computer signal. Press the
Menu button on the projector keypad or remote control to open the menus.
From the Basic menu, select Reset to synchronize the projector settings
with the computer. See Chapter 2 in the online User Guide for more
information about adjusting the image settings with on-screen menus.
4.
The image fills the screen, but the text is fuzzy and hard to
read.
Set the mobile computer display resolution to the projector resolution
of 1024x768. If your mobile computer resolution is only 800x600 or
640x480, the projector automatically converts the resolution to
1024x768.
Adjust the focus ring and the zoom ring to obtain a sharper image.
5.
I can only see part of the computer image on the screen.
As in item 4. above, set the computer resolution to match the projector
resolution. Use the activation keys to display the projected image.
Use the Keystone key on top of the projector to square the image.
6.
How do I attach digital video equipment to the projector?
Insert the video cable into the video connector in the player.
Connect the opposite end to the projector S-Video connector.
(C) Copyright International Business Machines Corporation 2002. All
rights reserved. US Government Users Restricted Rights – Use,
duplication or disclosure restricted by GSA ADP Schedule Contract
with IBM Corp.