Installing the faucet - view/ wave, Unpack dispenser components, Hot & cool models only – InSinkErator H770 User Manual
Page 6: Is required, View / wave, For a standard 1, Sink/counter hole, Large washer required for sink holes larger than 1
Star Nut
Fiber
Washer
■
■
Unpack dispenser components.
■
■
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
■
■
Unscrew and remove threaded extension
from valve body. Do not discard, as you
will need this later (See Figure 1).
■
■
Leave small washers in place.
■
■
Feed tubes down through the hole in
the sink/counter until the base is at
rest. Set faucet at desired angle.
■
■
From under sink, slide 2
1
⁄
4
" fiber washer
over faucet base. Reinstall threaded
extension onto the base until snug.
Thread star nut onto extension until
snug (See Figure 2).
■
■
From under sink, slide 2
1
⁄
4
" fiber washer
over threaded extension. Thread star
nut onto extension until snug.
Hot & Cool models only
■
■
Attach the quick connector to the ends
of the copper tubes running from the
dispenser.
■
■
Install a white 3/8" tube into other end
of quick connector.
If sink/counter thickness exceeds 3/4"
a hole diameter of 1
1
⁄
2
" is required.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
2
A
C
View / Wave
View / Wave
Hot & Cool models only
6
For a standard 1
1
⁄
2
" sink/counter hole
■
■
Feed tubes down through the hole in
the sink/counter until the base is at
rest. Set faucet at desired angle.
Large washer required for sink holes larger
than 1
1
⁄
2
" or for porcelain sinks with radius
or beveled holes.
■
■
Before feeding tubes through sink
hole, remove extension. Place 2
1
⁄
4
"
large steel washer over threads on
faucet base. Reinstall extension.
B
View / Wave
Faucet is factory-ready for installation
into a standard 1
1
⁄
2
" sink/counter hole.
1
5
⁄
8
" Small
Steel Washer
2
1
⁄
4
" Large
Steel Washer
1
5
⁄
8
" Rubber
Washer
Standard 1
1
⁄
2
" hole
Hole larger than 1
1
⁄
2
"
Installing into hole smaller than 1
1
⁄
2
"
Star Nut
Fiber
Washer
Figure 1
Figure 2
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
1
5
⁄
8
" Small
Steel Washer
1
5
⁄
8
" Small
Rubber Washer
1
5
⁄
8
" Small
Steel Washer
1
5
⁄
8
" Small
Rubber Washer
INSTALLING THE FAUCET - VIEW/ WAVE