Invacare 1036794 - Manual (Page 4)

4
REAR ARMREST SOCKET
INSTALLATION ON WHEELCHAIRS
BUILT AFTER 7/00
Space Saver Armrest Sockets (FIGURE 4)
Space Saver Kit No. 1094952 includes the following:
DESCRIPTION QTY.
Armrest Brackets 2
Front Armrest Sockets 2
Rear Armrest Sockets 2
Tube Supports 2
Nylon Washers 4
Long Hex Screw 2
Short Hex Screw 6
Locknuts 6
Hex Locknut 2
1. Position armrest bracket into mounting position. Re-
fer to Owner’s Manual, supplied with the wheelchair,
for proper mounting positions.
FIGURE 4 - REAR ARMREST SOCKET INSTALLATION ON WHEELCHAIRS BUILT
AFTER 7/00 - SPACE SAVER ARMREST SOCKETS
Tube Support
Armrest
Socket
Washer
Armrest
Bracket
Wheelchair
Frame
Locknut
Tube Support
Armrest
Socket
Washer
Short Hex
Screw
Armrest
Bracket
Armrest Bracket
Armrest
Socket
Armrest Stop
MOUNTING HOLES
Short Hex
Screw
2. Install armrest bracket onto wheelchair frame and
secure using short hex screw and locknut. Securely
tighten.
3. Insert the tube support into the armrest socket ensur-
ing that the holes in the tube support align with the
holes in the armrest socket.
4. Install the armrest socket into the armrest bracket.
NOTE: Mounting hardware must be installed in the
oreintation shown in FIGURE 4.
5. Install short hex screw through armrest bracket,
washer, armrest socket, tube support, washer and
armrest bracket as shown in FIGURE 4.
6. Secure with locknut.
7. Install remaining short hex screw (used as armrest
stop) through armrest bracket and secure with lock-
nut.
8. Repeat this procedure for the opposite side of the chair
frame.