Invacare 1036794 - Manual (Page 5)

5
DETAIL “A” - TOP VIEW
LEFT RIGHT
Wheelchair
Frame Tube
Support
Armrest
Socket
Hex
Screw
Armrest
Bracket
Spacer
Coved
Armrest
Spacer
Coved
Armrest
Spacer
Conventional Armrest Sockets (FIGURE 5)
Conventional Kit No. 1094953 includes the following:
DESCRIPTION QTY.
Armrest Bracket 2
Bracket Spacer 2
Front Armrest Socket 2
Rear Armrest Socket 2
Coved Armrest Spacer 2
Tube Supports 2
Nylon Washers 2
Long Hex Screw 2
Medium Hex Screw 2
Short Hex Screw 2
Locknuts 4
Hex Locknut 2
FIGURE 5 - REAR ARMREST SOCKET INSTALLATION ON WHEELCHAIRS BUILT
AFTER 7/00 - CONVENTIONAL ARMREST SOCKETS
Wheelchair
Frame
Locknut
Tube Support
Armrest
Socket
Short
Hex
Screw
Armrest
Bracket
Spacer
Coved
Armrest
Spacer
Washer
1. Position armrest bracket into mounting position. Re-
fer to Owner’s Manual for proper mounting positions.
2. Install armrest bracket onto wheelchair frame and
secure using short hex screw and locknut.
3. Insert the tube support into the armrest socket ensur-
ing that the holes in the tube support align with the
holes in the armrest socket.
4. Install the armrest socket into the armrest bracket.
NOTE: Mounting hardware must be installed in the
oreintation shown in FIGURE 5.
5. Install long hex screw through armrest socket, tube
support, coved armrest spacer, washer, armrest
bracket, spacer and armrest bracket as shown in DE-
TAIL “A”.
NOTE: Ensure armrest socket is flush in coved spacer.
6. Secure with locknut.
7. Repeat this procedure for the opposite side of the chair
frame.
Long
Hex
Screw