iHome IP97 - Manual (Page 9)

iP97 does not turn on AC adaptor isn't plugged into a working wall
socket or not plugged into the power supply
jack on back of the unit Plug the AC adaptor into a working wall socket and plug the connector
into the supply jack on the unit
iP97 requires a reset If unit is plugged in and doesn't respond, try resetting the unit by
following these steps:
a) remove iPhone/iPod from dock
b) unplug unit from power source
c) remove back up batteries
d) wait 1 hour, then resume use
iPhone/iPod is not docked properly Remove your iPhone/iPod from the dock and check for obstruction on
the connectors in the dock and on your iPhone/iPod. Then reseat it in
the dock.
Battery Low icon
always flashing Batteries are weak Replace with new batteries
Batteries were not installed properly Check to make sure the polarity ( + and – ends) matches the diagram
in the battery compartment
iPhone/iPod does not
respond to the unit/iPod
is playing but no sound
comes out iPhone/iPod is not docked properly Remove your iPhone/iPod from the dock and check for obstruction on
the connectors in the dock and on your iPhone/iPod. Then reseat it in
the dock.
Your iPhone/iPod software is too old Upgrade software on your iPhone/iPod. For details visit
http://www.apple.com or use iTunes on your computer
iPhone/iPod is locked up/plays but no sound
comes out Check the volume setting. Make sure your iPhone/iPod is working
properly before docking into the unit. Please refer to your
iPhone/iPod manual for details. See above for software upgrade
information.
You may need to reset your iPhone/iPod. Refer to your iPhone
or iPod user guide for details on how to perform a reset.
Using 1
st
or 2
nd
generation iPod, iPod Shuffle or
other devices.
iP97 cannot control those iPod models or other devices.
iPhone/iPod didn’t
charge up iPhone/iPod is not installed properly Remove your iPhone/iPod from the dock and check for obstruction on
the connectors in the dock and on your iPhone/iPod. Then reseat it in
the dock.
iPhone/iPod is locked up/ frozen
iPhone/iPod battery has problem
Please make sure your iPhone/iPod is working properly before docking
into the unit. Please refer to your iPhone/iPod manual for details.
No AM band radio
sound but others OK AM loop antenna is not connected to the unit Plug the AM loop antenna connector to the jack on the back of the unit
AM band radio is very
noisy AM loop antenna isn’t located properly Move the AM loop antenna away from the main unit AC adaptor and
rotate it for best reception
7
Troubleshooting
Solution Symptom Possible Problem
No sound from iP97 Volume is set too low on iP97 Make sure volume is turned up
Remote Control didn’t
work Battery weak Replace current battery with new battery
Remote Control is out of range of the iP97
remote sensor Move within 30 feet of the unit.
Move unit away from potential sources of external interference such as
computers, modems, wireless devices (routers) or fluorescent light. iP97/iPhone/iPod
performance is erratic The iP97 is reacting to external interference
iP97 doesn’t respond