Assemblies (figure 1), Tools needed – Invacare 9000 User Manual

Page 5

Advertising

NOTE: The procedures in this manual should be per-
formed on the specific side of the wheelchair the CLD
was ordered for.

ASSEMBLIES (FIGURE 1)

The Cyclical Lever Device (CLD) consists of several as-
semblies shown in FIGURE 1 and described on this page.
For proper installation follow INSTALLING CLD ON EX-
ISTING WHEELCHAIR in PROCEDURES 1-6 and per-
form PROCEDURE 7.

The following five (5) items are included in each kit. Each
numbered line represents a complete assembly;

Wheelchairs Built BEFORE 09/05/00 -
1. Hub Attachment, Transmission and Wheel Lock
2. Drive Arm Assembly, Support Bracket, and Steering

Link

3. Drive Arm
4. Fork Assembly
5. Front Rigging Release Handle

A
S
S
E

L
Y

PROCEDURE 1

ASSEMBLY

FIGURE 1 - ASSEMBLIES

This Procedure includes the following:

Assemblies

Tools Needed

Wheelchairs Built AFTER 09/05/00
1. Transmission and Wheel Lock
2. Drive Arm Assembly, Support Bracket and Steering

Link

3. Upper Drive Arm
4. Fork Assembly
5. Rear Wheel Mounting Hardware

TOOLS NEEDED

NOTE: Have the following tools available.

Torque Wrench
7/16-inch Socket or Box Wrench
7/16-inch Open End Wrench
1/2-inch Socket or Box Wrench
11/16-inch Socket or Box Wrench
3/4-inch Socket or Box Wrench
5/32 Hex Key
3/16 Hex Key
No. 1 Phillips Screw Driver
*M13 Socket or Box Wrench - Wheelchairs Built

BEFORE 09/05/00 ONLY

6MM Hex Key - Wheelchairs Built BEFORE 09/05/00

ONLY

*And adjustable wrench can be used in place of the M13
wrench.

Wheelchairs Built BEFORE 09/05/00

Wheelchairs Built AFTER 09/05/00

Hub

Attachment

(Rear Wheel

Mounting

Hardware)

Steering Link

Wheel Lock

Fork

Assembly

Drive Arm Assembly

Upper

Drive

Arm

Transmission

Support

Bracket

NOTE: Right side final assembly shown.