IBM T56A - Manual (Page 14)

A2
Important Precautions
On Installation
1. Do not allow anything to rest upon or roll over the power cord, and do not place
the monitor where the power cord is subject to damage.
2. Do not use this monitor near water such as near a bathtub, washbowl, kitchen
sink, laundry tub, in a wet basement, or near a swimming pool.
3. Monitors are provided with ventilation openings in the cabinet to allow the release
of heat generated during operation. If these openings are blocked, built-up heat
can cause failures which may result in a fire hazard. Therefore, NEVER:
Block the bottom ventilation slots by placing the monitor on a bed, sofa, rug,
etc.
Place the monitor in a built-in enclosure unless proper ventilation is provided.
Cover the openings with cloth or other material.
Place the monitor near or over a radiator or heat source.
4. Do not rub or strike the Active Matrix LCD with anything hard as this may scratch,
mar, or damage the Active Matrix LCD permanently.
5. Do not press the LCD screen with your finger for a long time as this may incur
some afterimages.
6. The LCD contains over 2,300,000 thin-film transistors (TFTs). A small number of
missing, discolored, or lighted dots on the screen this is an intrinsic characteristic of
TFT LCD technology and is not an LCD defect. If there is a problem with the LCD,
contact your IBM representative.
7. Optimum performance of your 9483 is achieved at 1024x768@60Hz. Other
modes should be used for diagnostic & setup purpose only.
On Cleaning
Unplug the monitor before cleaning the face of the LCD Screen.
Dust the monitor by wiping the screen and the cabinet with a soft, clean cloth. If
the screen requires additional cleaning, use a clean, damp cloth.
Do not use liquid cleaners, solvents or abrasives to clean this product.
On Repacking
Do not throw away the carton and packing materials. They make an ideal
container in which to transport the unit. When shipping the unit to another
location, repack it in its original material.