IBM T56A - Manual (Page 16)

A4
Connect to an APPLE Macintosh System
Figure shows the connection to an Apple Macintosh, using a separately
purchased adapter. For more information on adapter requirements, contact your
IBM authorized dealer for PartNumber 96G2694.
Power OFF both the monitor and the MAC.
Locate the appropriate MAC to VGA adapter block at your local computer store.
This adapter changes the high density 3 row 15 pin VGA connector to the
correct 15 pin 2 row connection to mate with your MAC. Attach the other end of
the signal cable to the side of the adapter block with 3 rows.
Connect the attached adapter block/signal cable to the video output on your
MAC.
Connect the plug from the AC-DC adapter into the connector on the display
unit.
Connect one end of the AC power cord into the AC-DC adapter. Plug
the other end into a properly grounded AC outlet.
Power ON the MAC, then the monitor.
If you see the Check Signal Cable message, check the signal cable and
connectors.
After using the system, power OFF the monitor, then the MAC.
Note : If you see the “Outside Range Limits” message, check to make sure your system is set
to one of the factory preset modes.(See pages A12 and A13)
7
6
5
3
2 1
4
3
2
1
Power Cord
Signal Cable
AC-DC adapter
D-15P
Adapter 15P
Connecting the Monitor
1
2
3