Janome MEMORY CRAFT 4900 QC - Manual (Page 23)

2 1
Threading the machine
z Raise the presser foot lifter.
x Turn the power switch on. Press the up/down needle
position button twice to raise the needle. The threading
light will light up.
q Threading light
NOTE:
If you want to use the handwheel to raise the needle,
make sure the threading light is on when threading.
Otherwise the machine will not be threaded properly.
z
x
c
v
b
n
m
,
q
c
w
e
r
v
u
c Draw the thread around the upper thread guide (A) w
and the upper thread guide (B) e .
w Upper thread guide (A)
e Upper thread guide (B)
v Draw the thread down along the right channel. Then
down around the bottom of the guide plate
r .
r Guide plate
b Firmly draw the thread up along the center channel to
the thread guide
t .While holding it with your right hand
behind the upper thread guide (A), firmly draw the
thread from right to left over the thread guide
t and
down into the chicane y .
t Thread guide
y Chicane
n Then down through the lower thread guide u .
u Lower thread guide
m Slide the thread behind the needle bar thread guide i
on the left. Thread the needle from front to back or use
the needle threader.
i Needle bar thread guide.
i
u
y
t