Jackson Conserver XL2-CMR - Manual (Page 6)

15. Tie-wrap the wires so that they will be out of the way when the
cover is placed back on.
16. Using the cotter pin, re-attach the drain link. Ensure that after
putting the pin through that you pull back the ends to secure it in
place.
17. Slide the cover back on taking care not to pinch or smash any
wires.
18. Secure the cover using the (4) screws.
19. Proceed to the section entitled “AFTER MAINTENANCE
ACTIONS”.
AFTER MAINTENANCE ACTIONS
1. Reconnect the incoming water (if disconnected) and
turn on. Then restore power to the unit. Run the unit for at least 10
cyles to ensure that the drain solenoid is working properly. If any
problems arise you can contact Jackson Technical Service.
SPECIAL NOTES
1. Work performed on Jackson dishmachines by unautho-
rized or unqualified personnel may void the warranty. Before begin-
ning this or any other maintenance evolution on a unit under war-
ranty, you should contact a certified Jackson technician or Jackson
Technical Service. You can find a list of qualified service agencies
in the back of you unit’s installation manual.
SPECIAL PARTS
Drain Solenoid Replacment Kitt:
For 110 volt machines order 6401-003-08-58
For 230 volt machines order 6401-003-08-59
CONTACT INFORMATION
Jackson MSC Inc. provides technical support for all of the
dishmachines detailed in this manual. We strongly recommend that
you refer to this manual before making a call to our technical sup-
port staff. Please have this manual with you when you call so that
our staff can refer you, if necessary, to the proper page. Technical
support is available from 8:00 a.m. to 5:00 p.m. (EST), Monday
through Friday. Technical support is not available on holidays.
Contact technical support toll free at 1-888-800-5672. Please
remember that technical support is available for service personnel
only.
www.jacksonmsc.com
Conserver XL/XL2 Drain Slolenoid Replacement Instructions
Revision A (07/02/2005)
6