Recording features, Select channel to watch, Set counter display – JVC HR-J250E User Manual
Page 13: Reset counter, Display remaining time, Start recording, Engage itr mode, Set recording duration, Record one programme while watching another, Elapsed recording time indication
EN
13
Recording
Features
Record One Programme
While Watching Another
SELECT CHANNEL TO
WATCH
1
Once recording is in progress, all you need to do is to
set the channel controls on the TV for the station you
wish to view.
● The programme selected with the TV’s channel
controls appears on the TV screen while the one
selected with the recorder's TV PROG buttons is
recorded on the tape.
Elapsed Recording Time
Indication
You can check the exact time of a recording.
SET COUNTER DISPLAY
1
Press DISPLAY (or – –:– –) until a counter reading
appears on the dispay panel.
RESET COUNTER
2
Press COUNTER RESET or 0000 before starting
recording or playback.
● The counter is reset to “0:00:00” and shows the exact
elapsed time as the tape runs.
1
2
3
4
5
6
7
8
9
0
2
4
Tape Remaining Time
DISPLAY REMAINING TIME
1
Press DISPLAY (or – –:– –) until the time remaining on
the tape appears.
● The display panel shows the tape remaining time
with "
" displayed.
● By pressing the DISPLAY (or – –:– –) button, you can
change the display to show the counter reading,
channel position*, clock time or tape remaining time.
* channel position is not displayed during playback.
NOTE:
Depending on the type of tape used, there may be times when
the tape remaining time reading may not appear right away, or
is not correct. "– –:– –" may sometimes appear, or the display
may blink on occasion.
TV PROG
DISPLAY
– –:– –
0000
TV PROG
COUNTER RESET
Instant Timer Recording (ITR)
This easy method lets you record for from 30 minutes to 6 hours
(selectable in 30-min. increments), and shuts the recorder off
after recording is finished.
START RECORDING
1
Press RECORD on the recorder.
ENGAGE ITR MODE
2
Press RECORD again. "
" blinks and 0:30 appears on
the front display panel.
SET RECORDING DURATION
3
If you want to record for more than 30 minutes, press
RECORD to extend the time. Each press extends
recording time by 30 minutes.
NOTES:
●
You can only perform ITR using the RECORD button on the
recorder's front panel.
●
After you set the ITR time, the counter display appears.
●
To check the remaining time, press RECORD once during
recording and the remaining time will be displayed for about
5 seconds. Be careful not to press RECORD again within
these 5 seconds, or you will round the recording time up to
the next 30 minute increment.
RECORD