JVC AV 27F702 - Manual (Page 16)

Connections
16
To Connect: Plug one end of the AVCompu Link cable into the AVCompu Link input on your VCR,
D V D , or other Compu Link device. Plug the other end of the AV Compu Link cable into the AV C o m p u
Link input at the rear of the television.
Connecting to JVC AV Compu Link
JVC’sAV Compu Link feature makes playing video tapes or DVDs totally automatic. Simply insert
a pre-recorded tape* into your JVC-brand VCR or DVD into your JVC DVD player and the device
will automatically turn on and begin playback. At the same time, using the AV Compu Link, the
VCR or DVD player sends a signal to the television telling it to turn on and switch to the proper
video input
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you wish to
connect.If it is not, contact an authorized JVC Service Center for part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
NOTES:
* In order for the V C Rp l ay b a ck to begin automatically, the recording tabs must be removed from the
V H St a p e. If the tab is in place, automatic switching will occur when you push the V C R ’s P L AY bu t t o n .
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand V C R has “ A Code/B Code Remote Control Switching” (see your V C R ’s instruction
book), using V C R A Code will switch the T V to input 1.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see the HiFi’s
connection instructions for detailed connection info rm a t i o n .
• AV C O M P U LINK EX is compatible with the fo l l owing receive r s :R X - 6 6 4 V, RX-665V, RX-668VBK,
R X - 7 7 4 V, RX-778VBK, RX-884V, RX-888VBK, RX-1024V, RX-1028VBK, and later receiver models.
Illustration of AV-27F802
NEW F702/802 mini-IB 3/8/01 11:16 AM Page 16