JVC HR-J278EU - Manual (Page 28)

Filename [HRJ278EU3.fm]
Masterpage:Left
28
EN SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
8 POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the
power consumption while the recorder is turned off.
NOTES:
● During Power Save mode ...
... the front display panel will be turned off.
... the picture may be distorted momentarily when you turn on/
off the recorder.
● Power Save does not work when the recorder is in the Timer
mode.
8 COLOUR SYSTEM
PAL/NTSC : To record PAL signals, or play back a
PAL or NTSC tape.
MESECAM : To record SECAM signals, or play
back a MESECAM tape.
You can play back PAL, NTSC and MESECAM tapes, or
record PAL and SECAM* signals on this recorder. Select the
appropriate colour system.
* SECAM signals will be recorded as MESECAM on this recorder;
MESECAM is the designation for tapes with SECAM signals that
have been recorded on a MESECAM-compatible PAL video
cassette recorder.
NOTES:
About NTSC Playback
● Some TVs shrink the picture vertically and place black bars at
the top and bottom of the TV screen. This is not a malfunction
on the part of either the video recorder or the TV.
● The picture may roll up and down. This can be corrected using
the V-HOLD control found on some TVs. (This cannot be
corrected if the TV does not have a V-HOLD control.)
● The counter and tape remaining time readings will be incorrect.
● During search, still, or frame-by-frame playback, the picture will
be distorted, and there may be a loss of colour.
● Depending on the type of TV, the top and bottom portions of
superimposed displays may be cut off during NTSC playback.
HRJ278EU3.fm Page 28 Thursday, February 22, 2001 1:33 PM