Jura Capresso IMPRESSA F7/F8 - Manual (Page 17)

container. Push down gently (Fig.10).
• Close the holder for the cartridge so that it engages in the
water tank (Fig.11).
• Fill the water tank with fresh cold water and replace.
1. Turn machine off. Push and hold the Rinse Button until the
display shows CHG FILTER / OPEN TAP .
2. Place a 20 oz. container underneath the frother.
3. Turn the Steam/Water Selector to the water symbol.
FILTER RINSING .
For the next 90 seconds the machine will push water through
the filter and through the frother. Do not interrupt this process.
This activates the filter. The machine will stop automatically.
4. CLOSE TAP . Turn the Water/Steam Dial back to the cup symbol.
HEATING . READY .
17. ADJUSTING THE WATER HARDNESS
Over time, heated water inside the machine leads to calcium
deposit build-up, unless you use the Clearyl Water Filter. The
display will remind you when it is time to perform a decalcifying
cycle. The machine is set to level 2 (medium hard water). If you
have harder water you need to set it to a higher level. If you have
softer water you can set it to level 1. If you are not sure about
the hardness of your water, ask your local water company for
the "Water Hardness in Grains."
Level 1: grains 2-9 • Level 2: grains 10-19 • Level 3: grains 20-29
Level 4: grains 30+
You can also use the enclosed water hardness indicator strip to
determine the water hardness:
• Insert the stick for one second into the water you want to
use. Shake off any access water and wait for one minute.
• If all five fields of the test stick turn reddish, set the hardness
level to 4. If four fields turn reddish, set the hardness level to 3.
If three or less fields turn reddish, leave the level in position 2.
• If you use Spring Water you can set the hardness level to 1.
You can change the hardness settings as follows:
1.Push and hold the P button (Fig. 3d).
FILTER – .
2.Turn the Rotary Dial until the display shows HARDNESS .
3.Push the Dial. LEVEL 2 .
4.Turn the Dial to select from 1 2 3 4 – .
5.Push the Dial to confirm your selection. HARDNESS .
6. Push the P button. READY .
Important: If you choose the selection " – " the water hardness
monitor is turned off and the machine will NOT remind you when
it is time to decalcify. Turning off the monitor requires you to either
use distilled water or the Water Filter Cartridge (chapter 16a).
18. PROGRAMMING
Please note: As long as you are in programming mode, you
cannot brew coffee.
• Push and hold the P button until the display shows
FILTER .
Turning the Dial clockwise the following functions will appear
in the display:
HARDNESS ... AROMA ... TEMP. ... TIME ... UNIT ON ...
OFF AFT. HR ... CUPS MADE ... LANGUAGE ... DISPLAY
To change functions the procedure is always the same:
1. Push and hold P button until display shows
FILTER .
2. Turn Dial to the function you want to change or look up.
3. Push Dial.
4. Turn Dial until desired selection is displayed.
5. Push Dial to confirm selection.
17.