Jura Capresso IMPRESSA F7/F8 - Manual (Page 23)

All supplies are available through:
• The enclosed mail order form that came with your machine
• Our toll free line at 1-800-220-5701 or
• The Internet at www.capresso.com.
23. FROTHXPRESS SYSTEM
This system and the Cappuccino Cleaner Liquid are included
with the F8 (sold separately for the F7). If you prepare many
cappuccinos or lattes at a time, this system is faster and easier
to use than the Dual Frother. It will automatically fill cup after cup
with your preferred amount of hot steamed and frothed milk,
without wasting any milk. See the separate instructions included
in the frothXpress box.
24. TROUBLESHOOTING
A. NO COFFEE COMES OUT OF THE COFFEE SPOUT
Reason: Beans in bean container are not properly feeding into
the grinder because they are stuck together.
Solution: Stir beans before grinding and while grinding turn the
grinding selector to the coarsest setting. See chapter 7.
Reason : You used ground coffee in the ground coffee funnel.
The ground coffee was too fine.
Solution: Use ground coffee which is ground somewhat coarser.
Reason : No water is transported through the system.
Solution: Remove water container and make sure that the con-
necting valve is free of any particles (like a coffee bean etc).
Reason: The ground coffee funnel or the internal brewing chamber
is clogged.
Solution: Place a cup underneath the coffee spout. Push the
Rinse button (Fig. 3g).
RINSING . Repeat the process if necessary
until the blocked coffee is pushed into the used coffee container.
B. THE DISPLAY READS "FILL WATER" BUT THERE IS
ENOUGH WATER IN THE WATER TANK.
Reason
: The low water floatation device (Fig. 7.4) is missing.
Solution: Within the water tank is a small compartment (like a
mouse trap). Inside is a small black floatation device. On top is a
small clear see-through plastic cover. This small plastic cover is
missing and the floatation device is outside of the small com-
partment. Check if you can locate both pieces and put it back
together. If you cannot find them, call 1-800-220-5701. We will
send the pieces to you FREE OF CHARGE.
C. INSUFFICIENT FROTHED MILK PRODUCTION
Reason
: Milk is initially not cold enough or your milk is not
suited for thick frothing.
Solution: Make sure milk is cold. Use a different type of milk.
Skim milk will produce the thickest and longest lasting froth.
Whole milk will produce less thick froth. See chapter 14.
Reason: The components of the frother are not assembled
properly, or the components are clogged with hardened milk, or
one or more of the components is missing, or the steam nozzle
is clogged.
Solution: (See chapter 15)
a. Remove frother. Check that steam comes out of the steam
nozzle. If not, use a needle and clear blockage from inside
steam nozzle.
b. Clean all other frother parts and assemble properly.
c. If any parts are missing either call Customer Service at:
1-800-220-5701 or use the enclosed mail order form to order
the missing part.
23.