John Lewis JLDWS1208 - Manual (Page 20)

If the drying results are not
satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid dispenser is only possible
with the Multi tab function active.
Activation/deactivation
of the rinse aid dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of
function buttons A, B and C start flashing.
3. Press function button B, the lights of
function buttons A and C go off while the
light of function button B continues to
flash. The digital display shows the current
setting.
rinse aid dispenser deactivated
rinse aid dispenser activated
4. To change the setting, press function
button B again, the digital display shows
the new setting
5. To memorize the operation, switch off the
dishwasher by pressing the On/off
button.
If you decide to revert back to
the use of individual detergents
we advise that you:
1. Deactivate the Multi tab function.
2. Fill up the salt container and the
rinse aid dispenser again.
3. Adjust the water hardness setting
to the highest setting and perform
1 normal washing programme
without loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the
water in your area.
5. Adjust the rinse aid dosage.
Select and start a washing
programme
Select the washing programme
and delay start with the door
slightly opened. The start of the
programme or the countdown of
the delay start will occur only
after the closure of the door.
Until then it is possible to modify
the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the
required programme (see "Washing
programmes" chart). Close the
20