JVC HM-HDS1U - Manual (Page 79)

EN
79
1 2 3
4 5 6
7 8 9
0
2
1
4
3
> <
1
2
– +
NOTE:
If you use an auxiliary input to connect a cable box or DBS
receiver, make sure that the correct AUX INPUT (“VIDEO” or “S-
VIDEO”) is selected after you have finished editing (
੬
pg. 22).
SET RECORDER’S INPUT
MODE
4
Press CH +/– to select depending on the connector
being used – “L-1” for the front panel input connectors,
or “R-1” for the rear panel input connectors.
NOTE:
If you use your recorder as the recorder and have
connected another VCR to your recorder´s S-VIDEO IN
connector, you need to set “REAR AUX INPUT” to “S-
VIDEO” at the Mode Set screen. Follow steps 5 – 7 from
the “Edit From A Camcorder” section (
੬
pg. 76 and 77).
SELECT “EDIT” FOR PIC-
TURE CONTROL SET MODE
(VHS DECK ONLY)
5
Follow the “Picture Control” section on page 44, then
select “EDIT.”
NOTE:
When you select “EDIT” to dub tapes, be sure to select
“AUTO” or (“NORM” when “VIDEO CALIBRATION” is
set to “OFF”) after you finish dubbing the tapes.
START PLAYER
6
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set “SUPERIMPOSE” to “OFF”
before pressing PLAY (
੬
pg. 28 for HDD deck, pg. 41
for VHS deck).
START RECORDER
7
Set to its record mode.
;;;
;;;
yyy
yyy DIGITPURE TECHNOLOGY
HM-HDS1
;;
;;
;;
yy
yy
yy
POWER
S-VHS ET S-VHS HDD
OK
MENU
REC LINK
CH
NAVI
STOP PLAY PAUSE REC
REW FEW
A. DUB
EJECT
VIDEO
PAUSE
S-VIDEO
(M) L – AUDIO – R
F - 1
CH+/
–
CH+/–
PLAY
PLAY