JVC HM-HDS1U - Manual (Page 84)

84
EN
DBS Receiver Multi-Brand
Remote Control
The recorder´s remote control can control functions on the
brands of DBS (Direct Broadcast Satellite) receivers listed
below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver’s remote
control.
SET REMOTE CONTROL
MODE
2
Press TV on the remote control when “CABLE DBS”
appears on the display window of the recorder’s remote
control.
ENTER DBS RECEIVER BRAND
3
Enter your cable box brand code using the NUMBER
keys, then press OK.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the
DBS receiver, you don´t have to repeat this step until
you replace the remote control´s batteries.
OPERATE DBS RECEIVER
4
First, press POWER to see if the DBS receiver’s power
goes off as it should. If it does, try other functions (TV
CH +/– and the NUMBER keys can be used to operate
the DBS receiver).
● For some brands of DBS receiver, you must press
ENTER after having pressed the NUMBER keys.
● To return the remote to the recorder control, press
HDD or VHS (or S-VHS).
DBS BRAND NAME BRAND CODE
JVC (DISH Network) 51
ECHOSTAR (DISH Network) 51
PRIMESTAR 50
SONY (DSS) 41
RCA (DSS) 40
NOTES:
● You must set the DBS receiver brand for your remote control
and the DBS receiver brand for your Controller (
੬
pg. 19)
separately.
● Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
● It's not possible to operate a DBS receiver that is not
equipped with a remote control sensor.
● Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
● It's not possible to set the remote control for both your DBS
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
SPECIAL FEATURES (cont.)
1 2 3
4 5 6
7 8 9
0
2
1
4
3
> <
1
2
– +
POWER
NUMBER
TV
HDD
OK
TV/VCR
ENTER/OK
TV CH +
TV CH –
VHS