Jensen JMC-326 - Manual (Page 10)

9
CD OPERATION
This Music System plays not only pre-recorded CDs but also self compiled CD-RW discs.
•
Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance are not guaranteed.
•
The distributor and retailer are not responsible for the playability of CD-R/RW due to
recording conditions such as PC performance, writing software, media ability, etc.
•
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
•
Should skipping of tracks occur during CD playing, try turning the volume down.
•
Do not open the CD DOOR at any time while either CD is playing.
The following tasks can be accomplished by using the controls either on the Music System or on the
REMOTE Control.
The icon
!
indicates that the task can only be done by the controls on the Music System.
1. Press once to turn the System on. The LCD backlight lights. The FM frequency reading
appears in the Display.
2. Press the FUNCTION Button once to enter CD mode. “CD1” and “Cd: - -” will appear in the
LCD Display with “- -” flashing. The Display will then show “Cd: “ ” after a few seconds since
no disc is loaded.
3.
!
Open the CD DOOR by gently pulling on the CD DOOR at the marking “
$
OPEN ”.
4.
!
Insert one or two CDs with the label side facing out, into the CD Compartments of Disc 1
and Disc 2 and then close the CD DOOR.
5. The total number of tracks on Disc 1 will be shown in the LCD Display after a few seconds.
PLAY/PAUSE MODE
1. When the Button is pressed during CD stop mode, the first track will be played. The Play
Indicator “
%
” (D1) will be shown in the top left-hand corner of the LCD DISPLAY. The LCD
DISPLAY will show the specific number of track, “Cd:01”, being played.
2. To Pause the CD during playback, press the Button once. The PLAY Indicator “
%
” (D1)
and the Track No. “01” will blink in the LCD DISPLAY.
3. The disc will continue to spin when paused. To resume playing, press the Button once
again. The PLAY Indicator “
%
” (D1) and the Track No. “01” will stop blinking and the music will
continue playing from the exact position where it was paused.
SKIP AND SEARCH MODE
4. In play or pause mode, when the
" or # Button is pressed once, the player will go to play the
next track or go back to the beginning of the track.
5. In play mode, when the " or # Button is pressed and held, the player will search the track with
audible high-speed forward or backward playback.
REPEAT PLAY MODE
6. Repeat 1:
When the REP/PRST Button is pressed once, the Repeat 1 Indicator “REP.1” (D16) will be
shown in the LCD DISPLAY. This single track of music will be played repeatedly.