JVC HR-J647MS - Manual (Page 12)

12
EN
PLAYBACK (cont.)
Manual Tracking
Your video recorder is equipped with automatic tracking
control. During playback, you can override this and adjust the
tracking manually by pressing the TV PROG buttons.
OVERRIDE AUTOMATIC
TRACKING
1
Press (SP/LP/EP) on the remote to engage manual
tracking.
ADJUST TRACKING
MANUALLY
2
Press TV PROG + or – to adjust tracking.
RETURN TO AUTOMATIC
TRACKING
3
Press SP/LP/EP ( ) on the remote to re-engage
automatic tracking.
NOTE:
When a new tape is inserted, the recorder enters the automatic
tracking mode automatically.
Repeat Playback
Your video recorder can automatically play back the whole tape
20 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ($) on the display panel blinks
slowly.
● The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
¶
1
4 ¢
7
3
8
¡
1 2 3
4 5 6
7 8
0
9
2
4
1
3
REVIEW
FF
PAUSE
PLAY
REW
C.MEMORY
PUSH JOG
C. RESET
TV PROG
Wide Quality
Use this function to improve image contrast which tends to
degrade especially with wide-screen TVs.
ACTIVATE WIDE QUALITY
1
During playback, press WIDE QUALITY on the recorder.
● The button will light up.
● Pressing the button again turns off the light.
● Turn on/off the light according to the type of playback
picture you want.
● The setting will remain effective even though you
turn on/off the recorder.
● This function is also effective with large-screen 4:3
aspect ratio TVs as well.
STOP
SP/LP/EP