Quick setup getting started, Key feature buttons, Basic operation – JVC AV-48WP55 User Manual

Page 12: Getting started step 1 – the remote control

Advertising

These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.

If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.

Before you can operate your remote control, you first need to install the batteries (included).

Lift and pull the latch on the back of the remote
control to open. Insert two batteries (included)
carefully noting the “+” and “–” markings, placing
the “–” end in the unit first. Snap the cover back
into place.

When you change the batteries, try to
complete the task within three minutes. If you
take longer than three minutes, the remote
control codes for your VCR, DVD, and/or
cable box/satellite receiver may have to be
reset. See pages 25 - 28.

Quick Setup Getting Started

Getting Started

Step 1 – The Remote Control

Key Feature Buttons

The four key feature buttons at the center of the remote can be
used for basic operation of the television. The top and bottom
buttons will scan forward and back through the available
channels. To move rapidly through the channels using
JVC’s Hyperscan feature, press and hold CH+ or CH–. The
channels will zip by at a rate of five channels per second. The
right and left buttons will turn the volume up or down. These
buttons are also marked with four arrows and are used with
JVC’s onscreen menu system. To use the onscreen menus,
press the M

ENU

button.

��

�

��

�

��

�

��

�

��

�

��

Basic Operation

Turn the television on and off by pressing the P

OWER

button at the top right corner

of the remote. If this is the first time you are turning on the TV, the interactive
plug-in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if

you need to operate a cable box.

• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to

DVD to control a DVD player. Please see pages 25 to 28 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

Advertising

Popular Brands

Popular manuals