JVC TK-C210FW - Manual (Page 21)

21
4. Connect the video signal cable. ( A pg. 14)
Lower the protection cover and connect the
connectors. Upon connecting, restore the
protection cover to cover the connectors.
5. Connect the input power supply cable.
(
A pg. 15)
6. Install the Ferrite core (TK-C210FW only)
(
A pg. 14)
7. Connect the alarm cable.
(TK-C215V12 only) (
A pg. 15)
8. Wrap insulation tape around cables.
Ⅵ Mounting
1. Align the position mark of the fastened
outer case with that of the camera unit.
NOTE:
When doing so, be careful not to catch the
cables in the outer case.
2. Turn the camera unit in the clockwise
direction.
T When doing so, ensure that the X mark is
visible. (See illustration below)
3. Fasten the camera by tightening the camera
fastening screw.
Ⅵ Adjusting Images
After mounting is completed, adjust the
images while checking the actual image.
(
A pg. 23 AAdjusting ImagesB)
FRONT
UP
3.
2.
1.
Be sure to loosen
the screw.
*TK-C215V4 is used in the above illustration
Attach from
the ceiling
slab
Adaptor ring
Fall preven-
tion wire
(not supplied)
Outer case
mounting screws
Less than 3mm
4.
8.
5.7.
Protection
cover
*TK-C215V12 is used in the above illustration
Alarm signal cable
(TK-C215V12 only)
Solder or crimp
Insulation tape
Wrap with tape
Input power
supply cable
3.
2.
1.
Position
mark
Camera
fastening screw
*TK-C215V4 is used in the above illustration
T Check
TK-S215_EN.book Page 21 Tuesday, March 28, 2006 9:39 AM