JVC TK-C210FW - Manual (Page 3)

3
I
ⅷ The unit is to be powered by a DC 12 V or an
AC 24 V power supply.
ⅷ The unit is to be powered by a UL Listed DC
12 V or an AC 24 V power supply. (For U type)
ⅷ The AC 24 V and 12 V DC power supply shall
conform to the following: Class 2 only (For
USA), Isolated power supply only (For
Europe).
ⅷ This installation should be made by a qualified
service person and should conform to all local
codes.
ⅷ This installation shall be in accordance with
the National Electrical Code, ANSI/NFPA 70.
ⅷ Any Mention in this manual of Alarm inputs
have not been evaluated by UL to be used for
Burglar Alarm Functionality.
ⅷ Embedding of cameras in the ceiling may not
be allowed due to regulations in some
regions. Please consult your nearby
authorized JVC dealer for more details.
ⅷ The ceiling to mount the camera has to be
strong enough to support the weight of this
product. If the ceiling is not strong enough,
make sure to apply reinforcement to the
ceiling before installation.
ⅷ Be sure to tighten the screws and nuts
securely, Insufficient tightening may cause the
unit to fall from its mount.
ⅷ The rating label is displayed on the side of the
camera unit.
ⅷ The camera unit may fall if the mounting
screws and nuts are not properly tightened.
Ensure that the screws and nuts are properly
tightened.
ⅷ We do not accept liability for any damage to
the camera in cases when it is dropped
because of incomplete installation due to not
observing the installation instructions
correctly. Please be careful when installing
the camera.
ⅷ Do not install the camera near lighting
equipment with a high temperature, such as
spotlights. Doing so may cause malfunction or
fire.
INFORMATION FOR USA
Ⅵ INFORMATION
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the
equipment and receiver.
● Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced radio/
TV technician for help.
Ⅵ CAUTION
CHANGES OR MODIFICATIONS NOT
APPROVED BY JVC COULD VOID
USER'S AUTHORITY TO OPERATE THE
EQUIPMENT.
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
ⅷ Before starting an important recording, be
sure to perform a test recording in order to
confirm that a normal recording is possible.
ⅷ We will not provide any compensation
whatsoever for the contents to be recorded or
loss of opportunities when recording is not
properly performed due to malfunction of the
video camera, VTR, hard disk recorder or
video tape.
ⅷ Prior to adjusting the shooting direction of the
camera, touch the metal surface of the
[MONITOR] terminal with your hand to
discharge static electricity from your body.
TK-S215_EN.book Page 3 Tuesday, March 28, 2006 9:39 AM