JVC KS-FX210 - Manual (Page 9)

9
ENGLISH
KS-FX210 [EN] GET0052-001A [J]
Other convenient tuner
functions
Scanning broadcast stations
When you press RPT/SCAN while
listening to the radio, station
scanning starts. Each time a
broadcast is tuned in, scanning
stops for about 5 seconds (tuned
frequency number flashes on
the display), and you can check
what program is now being
broadcast.
If you want to listen to that
program, press the same button
again to stop scanning.
Changing the AM/FM channel intervals
When using this unit in an area other than North
or South America:
When this unit is shipped from the factory, the
channel intervals are set to 10 kHz for AM and 200
kHz for FM. You can change the channel intervals
by following the procedure below.
1 Press SEL (Select) for more than 2 seconds.
“CLOCK H”, “CLOCK M” or “AREA” appears on
the display.
2 If “AREA” does not appear, press
4
or
¢
until it appears.
3 Press +.
“AREA EU” appears and the channel intervals
are set to 9 kHz for AM and 50 kHz (for manual
tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above
step 1 and 2, then press – in step 3 (“AREA US”
appears on the display.)
AREA EU : Select this when used in an area
other than North and South America.
AREA US: Select this when used in North or
South America.
RPT
SCAN
EN09-KS-FX210[J]f 10/8/01, 10:14 AM 9