Janome MEMORY CRAFT 4800 - Manual (Page 41)

40
Free Size Automatic Buttonhole 20
1 Stitch pattern: 20
2 Presser foot: Automatic buttonhole R
[1] Pull the button holder to the back (direction of A).
[2] Insert the fabric under the foot. Press the Up/down
needle button twice. Remove the fabric to the left to
draw both threads under the foot.
[3] Insert the garment under the foot, and lower the
needle at the starting point.
Then lower the automatic buttonhole foot.
1 Button holder
2 Needle thread
3 Bobbin thread
4 Starting point
[4] Sew down the left side stopping at the end of the
buttonhole mark. Press reverse button.
5 Reverse button
[5] Depress the foot control.
The machine will automatically bartack and sew up
the right side of the buttonhole.
Stop the machine when you are directly opposite the
first stitch on the left hand side.
Press the reverse button.
[6] Keep the foot control depressed. The machine will
bartack, knot the stitches and automatically stop
when the buttonhole is completed.
[7] Raise the presser foot.
To make the next buttonhole, position the fabric and
step down on the foot control.
The Memory Craft 4800 will sew another buttonhole
identical to the first each time you step down on the
foot control.
* If you would like to change the buttonhole size,
select buttonhole 20 again.
* If the right and left sides of density are not matching
(see page 55 ).
,
,
,
,
,
1 2
1
2
3 4
5
[1] [2] [3]
[4]
[5]
[6]
[7]
A