JVC GR-D22 - Manual (Page 13)

EN
13 TAPE RECORDING
Time Code
During recording, a time code is recorded on the tape.
This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code
begins counting from “00:00:00” (minute:second:frame).
If recording starts from the end of a previously recorded
scene, the time code continues from the last time code
number.
If during recording a blank portion is left partway
through the tape, the time code is interrupted. When
recording is resumed, the time code starts counting up
again from “00:00:00”. This means the camcorder may
record the same time codes as those existing in a
previously recorded scene. To prevent this, perform
“RECORDING FROM THE MIDDLE OF A TAPE” in the
following cases;
• When shooting again after playing back a recorded
tape.
• When power shuts off during shooting.
• When a tape is removed and re-inserted during
shooting.
• When shooting using a partially recorded tape.
• When shooting on a blank portion located partway
through the tape.
• When shooting again after shooting a scene then
opening/closing the cassette holder cover.
Display
RECORDING FROM THE MIDDLE OF A TAPE
1
Play back a tape or use Blank Search (
੬
pg. 14) to
find the spot at which you want to start recording, then
engage the Still Playback mode (
੬
pg. 13, “Normal
Playback”).
2
Set the Power Switch r to “ ” or “ ” while
pressing down the Lock Button e located on the
switch, then start recording.
NOTES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time code
indication does not move smoothly.
● The time code is displayed only when “TIME CODE” is
set to “ON” (
੬
pg. 24).
Frames
(30 frames = 1 second)
Seconds
Minutes
Frames are not displayed
during recording.
Normal Playback
1
Load a tape (
੬
pg. 9).
2
Set the Power Switch r to “PLAY” while pressing
down the Lock Button e located on the switch. To start
playback, press 6 6 .
• To stop playback temporarily (Still Playback), press
6 6 .
• To stop playback, press 7 4 .
• Press 1 5 to rewind, or ¡ 7 to fast-forward the
tape during Stop mode.
• High-speed picture search (Shuttle Search) is
possible by pressing 1 5 or ¡ 7 during playback
(holding 1 5 or ¡ 7 down during playback
continues search until released).
• At any time, pressing 6 6 resumes normal
playback.
To Control The Speaker Volume:
Rotate the MENU/VOLUME wheel
# so that the
volume level indicator i on the display moves to
obtain the appropriate volume.
ATTENTION
During Shuttle Search, parts
of the picture may not be
clearly visible, particularly on
the left side of the screen.
TAPE PLAYBACK
12 : 34 : 24
#
r e
5
4 6
7
Speaker
Continued on next page.
GR-D22_11-15_EN 25/9/03, 3:28 PM 13