Janome MEMORYCRAFT 300E - Manual (Page 8)

7
Winding the bobbin
1 Guide the thread around the bobbin winder thread
guide while holding the thread at the spool.
1 Bobbin winder thread guide
2 Thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
2 Bobbin winder spindle
3 Push the spindle to the right. Press the Start/Stop
button while holding the end of the thread. Stop
the machine after the bobbin has made a few
turns. Cut the thread close to the hole in the
bobbin.
4 Press the Start/Stop button again. When the
bobbin is fully wound it will stop automatically.
Press the Start/Stop button to stop the machine
then return the bobbin winder spindle to the left.
Remove the bobbin and cut the thread with the
bobbin thread cutter.
3 Bobbin thread cutter
NOTES:
Do not move the bobbin winder spindle while the
machine is running.
For safety purposes, the motor will stop automatically
after running for two minutes.
1
2
3
4
1
2
1
3
2