John Deere GREENSTAR BZ100157 - Manual (Page 22)

Installation Instructions
OUCC002,00021CA –19–18NOV06–8/8
ZX1037998
–UN–13SEP05
ZX1039592
–UN–10APR06
A—NIR sensor connector
B—Spout motor
C—Spout wiring harness
D—NIR sensor—BZ100165
E—Latch (3 used)
11. In Case Bundles BZ100157 and BZ100165 are
Installed on Spout:
Route NIR sensor connector (A) to the right-hand side
of the spout motor (B) then alongside the spout wiring
harness (C) up to the NIR sensor BZ100165 (D) as
shown. Secure cable with tie bands.
Make sure to route the cable so that it will not be
caught by any moving part.
12. Connect NIR sensor connector (A) to NIR sensor
BZ100165 (D) then engage the three latches (E) to
maintain NIR sensor BZ100165 (D) in working
position as shown.
IMPORTANT: Route cable as shown on illustration
and make sure to keep sufficient play to
cable so that NIR sensor assembly can
be folded/unfolded without
disconnecting connector (A).
NOTE: If connection box BZ100168 has been installed on
NIR sensor BZ100165 then connect NIR
connector (A) to the connection box (not
illustrated).
NOTE: Do not disconnect sensor (D) from spout wiring
harness until sensor shuts down completely.
Before disconnecting sensor turn forage harvester
ignition off. Wait at least 30 seconds prior to
disconnecting the sensor.
Z103757 (13DEC06)
20
Installation Instructions
011507
PN=22