JVC 0397MKV*UN*SN - Manual (Page 28)

28
EN
VIDEO CAPTURE (cont.)
INTERVAL CAPTURE
The Interval Capture mode is best suited for
capturing images at set intervals from a video
source unit with a JLIP connector.
Preparation
•Make sure all units are properly connected
(
੬
p. 12).
•Insert a tape into the video source unit.
Click "Image Format" in "Set-up" and select
"Field Picture" in the Capture Mode.
(
੬
p. 29).
1 Open the menu bar and click "Set-up" —
"Capture Mode" — "Automatic".
•The "Automatic Transfer" window
appears.
2 Select the data to be transferred.
•When you select "Index Image", index
image data (80 x 60 pixels) is transferred
to your computer.
•When you select "Index & Full Image",
both index image data (80 x 60 pixels)
and full image data (768 x 552 pixels) are
transferred to the computer.
3 Select "Interval Capture".
4 Set the interval.
•Select the time interval at which pictures
are captured.
5 Set the number of pictures to be captured
and click "OK".
•From 1 up to 99
6 Click "Window" — "VCR" to call up the
VCR Operation Window. Start video
playback a few seconds prior to the point
where you want image capturing to start.
7 Operate the video source unit via the VCR
Operation window and click the "Transfer"
button at the desired picture.
1. The message "No. 1 index image being
transferred" appears while the index image
data is being transferred to the computer.
2. When you select "Index & Full Image" in
step 2, the message "No. 1 full image being
transferred" appears while the full image
data is being transferred to the computer.
3. The message "Index No. 2 being scanned"
appears while the video data are fast-
forwarded and played at the time intervals
set in step 4 to scan the video data on the
VCR.
• The image selected when "Transfer" is
clicked is captured and subsequent images
are captured at the time interval specified
by the counter value selected in step 4.
• The video source unit enters the Pause
mode when capture is complete.
Set-up
Capture Mode
Image Format
Device Change
Initialize
ID Change
Counter Reset
Step by Step
Automatic
00:01:23:12F I
VCR
Capture
Transfer
NOTE:
• Make sure that enough hard disk space is
available on your computer before
executing video transfer.
For full image data space requirements,
੬
p. 24.
•Transfer of index image data/full image
data starts at the image box bordered in
green.
Click and select the desired image box.
•When transferring full image data using
the Bitmap image format (
9
.bmp), the
transfer takes a very long time, causing
the video source unit to stop playback
automatically.