Precaution for use, Compliance with fcc regulations – Jensen JIMS-260I User Manual
Page 5
4
•
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
PRECAUTION FOR USE
•
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE
MAINS VOLTAGE AND ALL OTHER CONNECTIONS HAVE BEEN MADE.
•
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE
OF SEVERAL CENTIMETERS AROUND THE UNIT FOR VENTILATION.
•
Places exposed to direct sunlight or close to heat radiating appliances such as
electric heaters.
IMPORTANT NOTES
Avoid installing the unit in locations described below:
•
Places subject to constant vibration.
•
Dusty, humid or moist places.
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.