Jensen JIMS-260I - Manual (Page 7)

INSTALLATION
FOR TABLE TOP USE
Attach the stand to the main unit as shown in figure 1a below. Attach the stands to the
speakers as shown in figure 1b below.
Fig. 1a Fig.1b
FOR WALL MOUNTING
1) Detach the stands from both
speakers and from the main unit.
2) Use the supplied wall-mounting
template to make anchor hole
marks on the wall. Make sure the
marks are level before drilling.
3) Drill 1/4” holes on the marks.
4) Insert the included plastic
anchors into the holes and push
in until they are flush with the
wall.
5) Insert the included screws into the anchors and tighten until the screw head is about
1/4” away from the wall. Line up the slots located on the back of the main unit and
speakers with the screws in the wall. See illustration below.
NOTE: This unit is not magnetically shielded and may cause color distortion on the
screen of some TVs or video monitors. To avoid this, you may need to move the unit
further away from the TV or monitor if unnatural color shifts or image distortion occurs.
6